Low cost, lightweight and high performance spring hanger isolators. For use installing on top of or under strut, under pipe trapeze or on angle brackets. Most typically used for supporting Fan Control Units. Supplied with our without a cage.
· FCU
· Fans
· Pipework
· Ductwork
· 10kg – 60kg
· 20mm
· IM-Y Unhoused
· HS-Y Housed
Low cost, high performance spring isolators. For use installing on top of strut, under pipe trapeze or on angle brackets.
· Fans
· Pumps
· Condensers
· Pipework
· Ductwork
· 16kg – 11331kg
· 25mm – 53mm
Light to heavy duty Spring Isolation Hanger. Hanger allows for a 30-degree swing of lower hanging rod. Perfect for installations where suspension points cannot be directly above equipment.
Compliant to AS1170.4 where RW30 is specified
· Fans
· Pumps
· Condensers
· Pipework
· Ductwork
· 5kg – 1252kg
· 25mm
· Seismic Rebound Washer (RW30)
· Pre-compressed (PC30)
· Pre-compressed & Seismic Rebound Washer (PC30S)
Hangers shall consist of rigid steel frame containing a steel spring seated in a steel washer reinforced LDS rubber cup on the bottom. The LDS rubber cup shall have moulded bushings projecting through the steel box. In order to maintain stability, the boxes shall not be articulated as clevis hangers. Spring and hanger lower hole diameters shall be large enough to permit the hanger rod to swing through a 30° arc from side to side before contacting the cup bushing and short circuiting the spring. Submittals shall include a hanger drawing showing the 30° capability. Hangers shall be type 30N as manufactured by Mason Industries, Inc.
Light to heavy duty Spring Isolation Hanger. Single spring to four spring arrays achievable with market leading capacity
· Fans
· FCU
· Condensers
· Pipework
· Ductwork
· 5kg – 3393kg
· 25mm – 50mm
· Seismic Rebound Washer (RWHS)
· Pre-compressed (PCHS)
· Pre-compressed & Seismic Rebound Washer (PCHSS)
Hangers shall consist of rigid steel frame containing a steel spring seated in a steel washer reinforced LDS rubber cup on the bottom. The LDS rubber cup shall have moulded bushings projecting through the steel box. Hangers shall be type HS as manufactured by Mason Industries, Inc.